Q-Card's Magnetic Stripe Track Location Gauge is designed to provide for fast and accurate go/no-go verification of the magstripe track location per ISO/IEC 7811-2, 7811-6 and 7811-7. Using this gauge in conjunction with Q-Card's Q-View magnetic developer, enables you to easily verify encoded track location.

Easy and Effective!
The Q-Card Opacity Tester is designed to test opacity using the existing and upcoming ISO specifications.
Test to ISO 10373-1 & 7810
860 or 950 nm Testing
End User Calibration

Allows you to examine magstripe magnetic encoding and make photomicrographs. A combination of tiny magnetic particles suspended in clear solvent liquid carrier in a convenient aerosol dispenser. Quantity discounts are available.

NOTE: $100.00 Minimum Order Required. Spray is compressed gas, all orders must ship Hazardous Materials and therefore, higher shipping rates will apply.

Q-Card’s Relative Height / Surface Profile of Contacts Fixture is designed to determine the difference in thickness between the ICC contacts and its adjacent surfaces to verify compliance to card industry testing per Mastercard® CQM and ISO standards.

The Q-Card Resistance to Heat Fixture is designed to perform this test according to ISO 7810 / ISO 10373-1 standards.

Q-Card’s Resistance to Impact fixture is designed to determine a card’s resistance to impact per ANSI, Mastercard® CQM and ISO standards.

Low Coercivity Calibration Card, Q-Card Calibrated, ISO ID1 size

High Coercivity Calibration Card, Q-Card Calibrated, ISO ID1 size

Q-Card's battery powered router tool conveniently and safely removes the material located behind the chip to prepare a card for the back of card spot pressure test. It is designed to be a much safer alternative to using a razor knife.

Q-Card's Sandpaper and Soft Eraser Rub Durability fixture is designed to determine the resistance of various card printing methods to abrasion caused by rough surfaces. Add the Consumable Kit below to get an extra set of 20 sandpaper pads, 2 eraser pads, 5 foam pads, and 2 card hold down clamping screws.

These are cards that simulate cut, abraded, scratched, warped, have variation in amplitude, etc.) They are generally used to compare the performance of one card reader against another.

The TC-JS card is especially useful for engineering tests.